Ranger Laser-Spot LS43B Installation And Operation Manual page 32

OPT (Optimize) Function
Not a Balancing Mode. The Optimize Function is an optional procedure to lessen the imbalance in a
Wheel that is more than 30 grams / 1 ounce out of balance.
For more information, refer to
HID (Hidden)
Lets you apply Adhesive Weights on the Center Plane in multiple locations mounted behind spokes.
This prevents them from being seen, as much as possible.
Refer to
Hidden Weight Balancing
Before You Balance a Wheel
Before you balance a Wheel, you should:
• Remove all existing Weights from the Wheel. If the Wheel already has Weights on it,
either Clip-On or Adhesive, take them off. They will throw off the new balancing process.
• Thoroughly clean the Wheel. Mud or dirt on the Wheel will impact the new balancing
process. Also, if you end up putting on Adhesive Weights, they get placed onto a clean area (so
they are less likely to fall off).
• Put on appropriate eye protection. Do not use the unit unless you are wearing ANSI-
approved eye protection: safety glasses, a face shield, or protective goggles.
• Make sure the area is clear. Only the operator should be near (within 30 feet) of the Wheel
Balancer while the Wheel is turning.
LS43B Laser-Spot™ Wheel Balancer
Using the Optimize
for specific instructions for using this Balancing Mode.
32
Function.
P/N 5900086 — Rev. A1 — 12/212018