Ranger Laser-Spot LS43B Installation And Operation Manual page 31

Balancing Modes
Balancing Modes are based on the locations where the weight gets put on if the Wheel is out of
balance:
• Dynamic (DYN). The most common Balancing Mode; used with steel rims. If the Wheel is out of
balance, weights go on the Inner Edge and the Outer Edge.
• Static (STA). Used for older Wheels under 4 inches wide and motorcycle Wheels. If the Wheel is
out of balance, weight goes on the Center Plane only.
• Aluminum 1 (ALU1). Used on Aluminum Alloy Wheels when you want the weights to go on the
Inner Plane and the Outer Plane.
• Aluminum 2 (ALU2). Used on Aluminum Alloy Wheels when you want the weights to go on the
Inner Edge and the Center Plane.
• Aluminum Special (ALUS). Used on Aluminum Alloy Wheels where the weights need to go on
the Inner Plane and the Center Plane.
LS43B Laser-Spot™ Wheel Balancer
31
P/N 5900086 — Rev. A1 — 12/212018