Operation - Ranger DST-64T Installation And Operation Manual

Operation

This section describes how to use your Wheel Balancer.
⚠
DANGER
Safety Precautions
Keep the following in mind while you use your Balancer:
• Make sure all Operators receive specific training in Wheel balancing
use the Balancer, that their training is verified through a testing program, and that all training is
documented. All others, including children and untrained personnel, must be kept at least 30 feet
away from the Balancer while it is in use.
• Make sure
• Do not use the Balancer while tired or under the influence of drugs, alcohol, or medication.
• Make a visual inspection of the unit
any issues. Instead, take the unit out of service, then contact your dealer, visit
www.bendpak.com/support/, or call (805) 933-9970.
• Keep the work area clean and well lit. Dirty, cluttered, and dark work areas increase the chances of
an accident happening.
• Do not remove the Tray unless instructed to do so by Ranger Support. There are no user
serviceable parts underneath.
must
• You
when installing, using, maintaining, or repairing the Balancer. Leather gloves, steel-toed work
boots, ANSI-approved eye protection, back belts, and hearing protection
⚠
WARNING
• Do not use the unit in a wet environment or expose it to rain or excess moisture.
• If an extension cord is necessary, you must use a cord with a current rating equal to or more than
that of the equipment. Cords rated for less current than the equipment may overheat. Arrange the
cord so that it will
• Do not use the Balancer in the vicinity of open containers of flammable liquids.
• Clean the Balancer according to the instructions in Maintenance.
Study
•
DST-64T / DST642D Wheel Balancers
Being in close proximity to a Balancer is a serious endeavor with potentially life-
threatening risks. Only trained, authorized, supervised personnel may be within 30
feet of the Balancer while it is in use.
safe using the Balancer this time just because nothing happened
last time
.
new
Operators are trained and supervised in the use of the Balancer.
wear OSHA-approved (Publication 3151) Personal Protective Equipment at all times
Always wear ANSI-approved eye protection. Although rare, an accident could
cause significant injuries to your eyes.
not
be tripped over or pulled out.
the entire Installation and Operation Manual before using the unit.
Do not assume you are going to be
before each use
. Do not operate your Balancer if you find
24
before they are allowed to
are mandatory
P/N 5900192 — Rev. F — March 2021
.