Operation - Ranger DST30P Installation And Operation Manual

Table of Contents

Advertisement

Operation

This section describes how to use your Balancer.
DANGER
Usage Precautions
Keep the following in mind while using the Balancer:
Make sure all Operators receive specific training in Wheel balancing
use the Balancer, that their training is verified through a testing program, and that all training is
documented. All others, including children and untrained personnel, must be kept at least 30 feet
away from the Balancer while it is in use.
Make sure
Do not use the Balancer while tired or under the influence of drugs, alcohol, or medication.
Make a visual inspection of the Balancer
find any issues. Instead, take the unit out of service, then contact your dealer, visit
www.bendpak.com/support/, email support@bendpak.com, or call (805) 933-9970.
Keep the work area around the Balancer clean and well lit. Dirty, cluttered, and dark work areas
increase the chances of an accident happening.
Do not remove the Trays on the top of the Balancer unless instructed to do so by BendPak Ranger
Support. There are no user serviceable parts underneath.
must
You
when installing, using, maintaining, or repairing the Balancer. Leather gloves, steel-toed work
boots, ANSI-approved eye protection, back belts, and hearing protection
WARNING
Do not use the unit in a wet environment or expose it to rain or excess moisture.
If an extension cord is necessary, a cord with a current rating equal to or more than that of the
Balancer must be used. Extension cords rated for less current than the equipment may overheat.
Care should be taken to arrange the extension cord so that it will
Do not use the Balancer in the vicinity of open containers of flammable liquids.
Clean the Balancer according to the instructions in Maintenance.
Study the entire
DST30P Wheel Balancer
Being in close proximity to a Balancer is a serious endeavor with potentially life-
threatening risks. Only trained, authorized, supervised personnel may be within 30
feet of the Balancer while it is in use.
safe using the Balancer this time just because nothing happened
last time
.
new
Operators are trained and supervised in the use of the Balancer.
wear OSHA-approved (Publication 3151) Personal Protective Equipment at all times
Always wear ANSI-approved eye protection. Although rare, an accident could
cause significant injuries to your eyes.
Installation and Operation Manual before using the Balancer.
Do not assume you are going to be
before each use
. Do not operate the Balancer if you
23
P/N 5900163 — Rev. C1 — March 2020
before
they are allowed to
are mandatory
not
be tripped over or pulled.
.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents