Ranger Laser-Spot LS43B Installation And Operation Manual page 35

Static Balancing
Static Balancing is for older Wheels under 4 inches wide and motorcycle Wheels.
Note: The Optimize Function is
If the Wheel is out of balance, weight goes on the Center Plane when using Static Mode.
To Balance a Wheel using Static Mode:
1. Make sure you are wearing ANSI-approved eye protection: safety glasses, face shield, or goggles.
2. Visually inspect the Balancer to make sure everything is in place. The Hood should be
3. Mount the Wheel you want to balance.
Refer to
4. Turn the Balancer Off and then back On, to reset it.
5. On the Control Panel, press the F button until the STA (Static) indicator is lit.
6. Pull out the Inner Arm and place it on the Center Plane and hold it there;
to beep
7. When the Balancer beeps, return the Inner Arm to its normal location.
Numerical values appear in the Inner and Outer Windows. If they do not, it means the
measurement was not noted correctly by the Balancer and thus you will
balance the Wheel. Start over at Step 4.
8. Lower the Hood; the Wheel spins briefly.
9. Raise the Hood when the Wheel stops.
The Inner Window shows St and the Center Plane indicator is lit.
The Outer Window shows the weight you need to add to the Center Plane, if weight needs to be
added.
10. Turn the Wheel slowly to find the best location to put the weight.
11. When the Wheel is in the right location, it automatically locks and a laser beam appears at the spot
where the Balancer wants you to add the weight.
12. Add the correct amount of weight centered on the laser location.
13. Lower the Hood to spin the Wheel again.
The Outer Window shows 00 When the Wheel is balanced.
LS43B Laser-Spot™ Wheel Balancer
Mounting a Wheel
.
not
available for Static Mode.
for mounting instructions, if needed.
35
wait for the Balancer
not
be able to correctly
P/N 5900086 — Rev. A1 — 12/212018
up
.