Ranger Laser-Spot LS43B Installation And Operation Manual page 19

Installing the Shaft
The Shaft holds the Wheels you are balancing.
Tip
To install the Shaft:
1. Locate the Shaft Assembly and the Mounting Bolt from the parts supplied with the Balancer.
2. Clean the Shaft Assembly by removing the shipping grease and any dirt that has accumulated.
3. Put the Shaft Assembly into place next to the Shaft Housing and hold it there.
Note:
4. Put the Mounting Bolt into the end of the Threaded Shaft and begin tightening it.
5. Before fully tightening the Mounting Bolt, make sure the Alignment Marks are aligned (see drawing
below).
Not necessarily to scale. Not all components shown.
6. Tighten the Mounting Bolt into place.
LS43B Laser-Spot™ Wheel Balancer
Consider having two people on hand to install the Shaft: one person to hold the Shaft
Assembly in place while the second person screws in the Mounting Bolt. Also, consider
having some rags nearby; the Shaft comes greased to protect it.
It is easier to install the Shaft with two people.
19
P/N 5900086 — Rev. A1 — 12/212018