Ranger Laser-Spot LS43B Installation And Operation Manual page 15

Installing the Display Panel
The Display Panel shows information about what is happening during the balancing of a Wheel.
To install the Display Panel:
1. Locate the Display Panel and the Display Panel Mount Bar.
– The Display Panel Base Plate (located on the bottom of the Display Panel Mount Bar, see
drawing on previous page) connects to the back of the Balancer using four hex bolts, four split
lock washers, and four standard washers; these come connected to the back of the Balancer.
– The Display Panel connects to the Display Panel Mount Plate (located on the top of the Display
Panel Mount Bar) using four hex bolts that come connected to the back of the Display Panel.
2. Remove the four 6 mm hex bolts, four split lock washers, and four standard washers on the back
of the Balancer.
3. Put the Display Panel Base Plate into position, then install the four hex bolts, four split lock
washers, and four standard washers to secure it; tighten securely, but do not overtighten.
4. Remove the four 3 mm hex bolts from the center back of the Display Panel.
5. Put the Display Panel into place against the Display Panel Mount Plate, then install the four hex
bolts to secure it; tighten securely, but do not overtighten.
6. Run the cable from the back of the Display Panel down to the Connectors, then connect it to the
appropriate Connector.
Each of the three Connectors on the back of the Balancer are different, so make sure to connect
the Display Panel cable to the appropriate Connector.
The Display Panel Cable Connector has five holes in it.
LS43B Laser-Spot™ Wheel Balancer
15
P/N 5900086 — Rev. A1 — 12/212018