Ranger Laser-Spot LS43B Installation And Operation Manual page 20

Anchoring the Balancer
The Balancer has three holes for Anchor Bolts, which hold the Balancer in place while you use it.
Important:
To anchor the Balancer:
1. Move the Balancer to the desired location.
Remember that you need to allow some space around the Balancer. Refer to
Location
2. Using the holes in the base as guides, drill the holes for the M10 x 59 mm Anchor Bolts.
Go in straight; do not let the drill wobble. Use a carbide bit (conforming to ANSI B212.15-1994).
The diameter of the drill bit must be the same as the diameter of the Anchor Bolt. So if you are
using an M10 diameter Anchor Bolt, for example, use an M10 diameter drill bit.
3. Vacuum each hole clean.
BendPak recommends using a vacuum to get the hole very clean.
not
Do
4. Make sure the Washer and Nut are in place, then insert the Anchor Bolt into the hole.
The Expansion Sleeve of the Anchor Bolt may prevent the Anchor Bolt from passing through the
hole in the Base Plate; this is normal. Use a hammer or mallet to get the Expansion Sleeve through
the Base Plate and into the hole.
Even using a hammer or mallet, the Anchor Bolt should only go into the hole part of the way; this is
normal. If the Anchor Bolt goes all the way in with little or no resistance, the hole is too wide.
Once past the hole in the Base Plate, the Anchor Bolt eventually stops going down into the hole as
the Expansion Sleeve contacts the sides of the hole; this is normal.
LS43B Laser-Spot™ Wheel Balancer
required
You are
Balance can result in inaccurate readings.
for additional information.
not
ream the hole. Do
to bolt your Balancer into place, as movement during a Wheel
make the hole any wider than the drill bit made it.
20
Finding a
P/N 5900086 — Rev. A1 — 12/212018