Ranger Laser-Spot LS43B Installation And Operation Manual page 29

Mounting a Wheel
When you want to balance a Wheel, the first step is to mount it on the Shaft.
Important:
There are three ways to mount a Wheel onto the Shaft:
• Front-Cone Mounting. The preferred method, as it generally produces the most accurate
balancing results.
An appropriately sized Mounting Cone goes on after the Wheel, then the Quick Nut.
• Rear-Cone Mounting. Use this method if the Wheel you are balancing cannot be mounted with
Front-Cone Mounting.
The Spring goes on first, then an appropriately sized Cone, the Wheel, the Quick Nut Cap, and
finally the Quick Nut.
LS43B Laser-Spot™ Wheel Balancer
All Wheels should be mounted so that the inside (the side of the Wheel that goes
closest to the Vehicle) goes on the Shaft first.
29
P/N 5900086 — Rev. A1 — 12/212018