Installation - Ranger Laser-Spot LS43B Installation And Operation Manual

Installation

This section describes how to install your Balancer.
Installation Safety Rules
Pay attention at all times during installation.
clear of moving parts. Keep hands and fingers away from pinch points.
Use caution when unpacking the Balancer from its shipping container and setting it up. The Balancer is
heavy and the weight is not evenly distributed; dropping or knocking over the unit may cause
equipment damage or personal injury.
⚠
WARNING
Only allow experienced, trained technicians to install the Balancer. In particular, all electrical work
must
be done by a licensed, certified Electrician.
⚠
CAUTION
If you have to use an extension cord, make sure its current rating is equal to or greater than that of the
equipment being used. Make sure the extension cord cannot be stepped on, run over, or pulled out.
Extension cords are also a tripping hazard, so they must be secured.
Plan for Electrical Work
The Balancer does not come with a Plug on the end of the Power Cord; it is your responsibility to
supply the Plug and have an Electrician attach it to the Power Cord.
Refer to Wiring Diagram
⚠
WARNING
Tools
You may need some or all of the following tools:
• Hex key wrench set (four hex keys come with the unit: 3, 4, 5, and 8 mm in the Mount Bar box)
• SAE and Metric wrench sets
• Adjustable wrench
• Scissors, utility knife, or other cutting tool
• Hammer
LS43B Laser-Spot™ Wheel Balancer
You must wear appropriate protective clothing at all times during setup: leather
gloves, non-skid steel-toed work boots, ANSI-approved eye protection, and an
industrial back belt. Although rare, an accident could cause significant injuries. The
Balancer includes a laser spotter:
Certain parts of installing the Balancer are difficult for just one person. BendPak
Ranger strongly recommends having two or more persons work together to install
the Balancer.
for wiring information.
All electrical work, such as attaching the Plug to the Power Cord,
by a licensed, certified Electrician
electrical codes at your location.
Use appropriate tools and equipment. Stay
Do not look into the laser.
in accordance with all applicable
11
must be done
P/N 5900086 — Rev. A1 — 12/212018