Ranger Laser-Spot LS43B Installation And Operation Manual page 34

The value that appears in the Inner Window needs to be added to the Inner Edge of the Wheel.
The value that appears in the Outer Window needs to be added to the Outer Edge of the Wheel.
If either value is over 1 oz / 30 grams, Opt appears in the Width Window, meaning that the
Optimize Function can be used. Refer to
11. Lift the Hood.
12. Turn the Wheel slowly to find the best location to put the weight on the Inner Edge (if the Inner
Window shows 00, do not add any weight to the Inner Edge).
The Inner Plane indicators light up or go out as you move the Wheel to find the best location to put
the weight.
13. When the Wheel is in the right location, the Wheel automatically locks in position and a laser beam
appears at the spot on the Wheel where the Balancer wants you to add the weight.
14. Add the correct amount of weight centered on the laser location.
15. Press Stop to release the Wheel from the automatic lock.
16. Turn the Wheel slowly again to find the best location for weight on the Outer Edge (again,
assuming it needs weight; if the Outer Window shows 00, do not add weight to the Outer Edge).
17. Add the correct amount of weight when the Wheel locks and the laser beam appears.
18. Lower the Hood to spin the Wheel again.
The Wheel is balanced when both the Inner and Outer Windows show 00.
LS43B Laser-Spot™ Wheel Balancer
Using the Optimize Function
34
for more information.
P/N 5900086 — Rev. A1 — 12/212018