21. Press the ALU button.
SPD appears.
22. Get the weight ready to be put on.
23. Turn the Wheel by hand until all of the Weight Position indicators on the OUTER side are fully
illuminated.
24. Apply the weight displayed in the OUTER Window.
25. Turn the Wheel by hand again until all of the Weight Position indicators on the OUTER side are
fully illuminated again.
26. Apply the weight displayed in the OUTER Window.
27. Lower the Hood to spin the Wheel again.
The Wheel is balanced when both the INNER and OUTER Windows show 00.
Maintenance
Make sure your Wheel Balancer is maintained on a regular basis.
Regular Maintenance
⚠
WARNING:
To maintain your Wheel Balancer:
•
Daily: Make sure the unit is clean and dry before using it.
•
Weekly: Make sure the Shaft Assembly is correctly oriented with the Shaft Housing and is
securely tightened.
•
Monthly: Make sure all Anchor Bolts are tightened and secure.
•
Monthly: Check all components to make sure they are in good operating condition. If you find a
component that is
Troubleshooting
•
Every three months: Check the bolts on the components attached to the rear of the unit to
make sure they are tight and secure.
•
Yearly: Have an Electrician come out and check the electronic components.
•
Yearly: Take the unit out of service, disconnect the Power Cord from the power source, and then
thoroughly check and clean all components.
⚠
WARNING:
LS43B Laser-Spot™ Wheel Balancer
Disconnect the Power Cord from power
maintenance
and take whatever steps are necessary to make sure the unit
cannot be re-energized until Maintenance is over. Because the unit uses electricity,
you could be electrocuted or even killed if the unit is powered back on during
Maintenance.
not
working correctly, take the unit out of service and refer to
for more information.
Do not operate your Wheel Balancer if you find issues; instead, take the unit out of
service, then contact your dealer, visit rangerproducts.com/support/, or call
(805) 933-9970.
before performing any
39
P/N 5900086 — Rev. A1 — 12/212018