Ranger Laser-Spot LS43B Installation And Operation Manual page 17

Installing the Hood
The Hood covers the Wheel while it spins during a Balancing.
⚠
CAUTION
Important:
To install the Hood:
1. Locate the Hood, the Hood Mount Bar, and the hex bolts and washers required to connect them.
– The Hood connects to the Hood Mount Bar using two 5 mm hex bolts and washers; these
come from the factory in place.
– The Hood Mount Bar connects to the Mount Box via a large hole in one end of the Hood
Mount Bar.
2. Put the hole on the bottom end of the Hood Mount Bar over the silver rod on the left side of the
Mount Box, align the holes, then tighten the 4 mm screws.
Make sure to set up the Hood Mount Bar so that the rubber stop piece hits the back of the
Balancer when the Hood Mount Bar is in its forward position.
3. Find the large silver washer and 8 mm bolt, put the washer and bolt into place where the Hood
Mount Bar slid over the silver rod on the Mount Box, then tighten the 8 mm bolt into the end of the
silver rod.
4. Remove the two 5 mm hex bolts and the split lock washers from the top of the Hood Mount Bar.
They come from the factory in place.
5. Put the Hood into position next to the top of the Hood Mount Bar.
6. Replace the two 5 mm hex bolts and split lock washers you just removed; tighten them securely.
7. Route the cable from the bottom of the Mount Box to the Connectors, then connect the end of the
cable to the appropriate Connector.
The Hood Cable Connector has two holes in it.
LS43B Laser-Spot™ Wheel Balancer
Keep away from the Hood and the Wheel while the Wheel is spinning. Touching the
Wheel while it is spinning could result in injury.
The following procedure assumes the Mount Box is already installed. If the Mount Box
is not already installed, you must do it now.
17
P/N 5900086 — Rev. A1 — 12/212018