Yamaha DME4io-ES Service Manual page 52

DME4io-ES/DME8i-ES/DME8o-ES
y Setting Ethernet
([Control panel] → [Network connection] → [Local area connection] → [Property] → [Internet Protocol (TCP/IP)] →
[Property]: In case of Windows XP)
IP address
Subnet Mask
u DME-N NETWORK driver setup (in case of V1.0.0 system)
In case of V1.0.0 system, set up as follows. In case of V1.1 or higher, input IP address.
([Control Panel] → [DME-N Network Driver])
Device No.
Device Name
IP Address
Protect No.
Device ID
TCP-KEEPALIVE
1-3. Setup of the NAI48-ES as a jig
q Download the AVS-ESMonitor software from the YSISS Home Page.
w Install the AVS-ESMonitor software to the personal computer and set up the NAI48-ES as shown in the fi gure below.
∗ To download the latest version, download from the website by Auvitran (http://www.auvitran.com).
e Connect the AES/EBU connector 1 (1 – 8 ch) and connector 2 (9 – 16 ch) with the Dsub25P (YAMAHA compatible
arrangement) cable and perform 8 ch loopback
52
192 168 0 1
255 255 255 0
1
ZONE1
192 168 0 2
00 A0 DE 25 00 00
1
on