Yamaha DME4io-ES Service Manual page 102

DME4io-ES/DME8i-ES/DME8o-ES
UPDATING PROGRAM AND BOOT
1. Connection to PC
Connect the LAN terminal of the PC and the NETWORK terminal of the DME Satellite with a LAN cross cable.
2. Activating the DME Satellite
Set the DIP SWITCH as follows and turn on the power to the DME Satellite.
Left
U U U U D D
U: Up
D: Down
3. Activating the update software
The update software for program and the update software for boot are different as shown below.
• Program
Click on the icon "update" of C:/¥TOOLS_SATELLITE¥tools¥update¥prog¥.
• Boot
Click on the icon "update" of C:/¥TOOLS_SATELLITE¥tools¥update¥boot¥.
4. Setting the parameters
When update software is activated, the setting and executing screen is displayed. (See Setting and executing screen)
Set the parameters according to the following parameters.
Output Port : ZONE1
Input port : ZONE1
Target ID : 2
Firmware : Select either PROGRAM or BOOT for which you wish to update.
Download File : Select either C:¥TOOLS-SATELLITE¥prog¥DMEIO-BOOT.BIN or C:¥TOOLS-SATELLITE¥prog¥DMEIO-
PROG.BIN for which you wish to update.
[Setting and executing screen] (Boot)
102
Right
Update Download File
BOOT C:¥TOOLS_SATELLITE¥prog¥DMEIO_BOOT.BIN
PROGRAM C:¥TOOLS_SATELLITE¥prog¥DMEIO_PROG.BIN
[Setting and executing screen] (Program)