Yamaha DME4io-ES Service Manual page 106

DME4io-ES/DME8i-ES/DME8o-ES
WRITING COMPONENT/SCENE DATA
1. Connection to PC
Connect the LAN terminal of the PC and the NETWORK terminal of the DME Satellite with a LAN cross cable.
2. Activating the DME Satellite
Set the DIP SWITCH as follows and turn on the power to the DME Satellite.
Left
U U U U D D
U: Up
D: Down
3. Activating the software for writing component/scene data
Click on the icon "sync" of C:¥TOOLS_SATELLITE¥tools¥sync¥component¥.
4. Setting the parameters
Set the parameters according to the following parameters.
Output Port : ZONE1
Input port : ZONE1
Target ID : 2
Execution fi le : C:¥TOOLS_SATELLITE¥component¥DMESATELLITE.dat
Component data writing can be started if all the parameters are correct.
5. Writing component/scene data
Click on "Execute...".
The writing is fi nished when the "Command execution fi nished" is displayed.
All DIP SWITCH set to the upper position.
106
Right
[Setting and executing screen]