Yamaha DME4io-ES Service Manual page 108

DME4io-ES/DME8i-ES/DME8o-ES
7. Confi rming the writing component
7-1. Before the connection
If the DME Satellite is activating, turn off the power to the DME Satellite.
After checking that the power to the DME Satellite is turned off, activate the DME Satellite.
∗ If the confi rmation of writing component is executed without restarting the DME Satellite after writing component,
version of the component may not got correctly. Therefore, be sure to execute the confi rmation of writing component
after restarting the DME Satellite.
7-2. Connection to PC
Refer to Procedure 1 "Connection to PC" (P. 106) of "Writing component/scene data".
7-3. Activating the DME Satellite
Refer to Procedure 2 "Activating the DME Satellite" (P. 106) of "Writing component/scene data".
7-4. Activating the software for writing component/scene data
Refer to Procedure 3 "Activating the software for writing component/scene data" (P. 106) of "Writing component/scene
data".
7-5. Setting the parameters
Refer to Procedure 4 "Setting the parameters" (P. 106) of "Writing component/scene data".
7-6. Confi rming the writing component
Click on "Check...".
If "V3.0x" is shown for the component group version, the writing is fi nished successfully.
Check that the version is identical to the program version.
∗ The "V ∗.∗∗" shows the component version, as "V3.0x" in the [Writing completed confi rmation screen] in the next page.
If "Error!!" is shown, it indicates that the component data is not written successfully. Write the component data again.
When the writing is completed, set the DIP SWITCH to the original position (all switches at upper position).
108