Yamaha DME4io-ES Service Manual page 103

5. Updating
Click on "Connect...".
When "Connection succeeded." is displayed, click on "Update Firmware..". (See [Checking connection screen].)
When "Firmware update completed." is displayed and then DME Satellite is restarted, updating is end. (See [Update
completed screen].)
If the VNP1 needs fi rmware updating, the updating will be started. (Refer to "Writing VNP1 Firmware" (P. 114))
All DIP SWITCH set to the upper position.
[Checking connection screen] (Boot)
[Update completed screen] (Boot)
6. Solution when error message is displayed
When the error message as shown below is displayed, stop updating software, restart the DME Satellite, and start
updating from the beginning again.
If the same message is still displayed after restarting the updating software and the DME Satellite, restart the personal
computer and the DME Satellite, start updating software and start updating from the beginning again.
Error messages list
"[Error] Device unreachable."
"[Error] Port unreachable."
"[Error] Product name unavailable."
"[Error] SysEx memory full."
"[Error] File cannot open."
"[Error] Illegal fi le format."
[Checking connection screen] (Program)
[Update completed screen] (Program)
"[Error] Memory full."
"[Error] File cannot be read."
"[Error] Port control failed."
"[Error] Command packet size unavailable."
"[Error] Command packet memory full."
"[Error] Command packet creation failed."
DME4io-ES/DME8i-ES/DME8o-ES
103