Installation And Removal Of Drive Racks - Siemens Simatic IPC647C Operating Instructions Manual

Expansions and parameter assignment
10.4 Drive racks and storage media
10.4.2

Installation and removal of drive racks

Preparations
5. Disconnect the device from the power supply and remove all connecting cables from the
6. Open the device as described in section
7. Open the front panel of the device.
8. Remove the bus frame before removing the vibration damped drive rack as described in
Removing drive racks
How to remove the drive rack
1.
2.
3.
80
device.
the section I nstallation and removal of the bus frame (Page
4
when removing the drive rack with a removable rack.
Loosen the identified screws
with Torx T10 screwdriver.
Loosen the identified screws
behind the front panel with a
Torx T10 screwdriver.
Pull the power plugs for the
Slimline drive rack and any
mounted SSD drives on the
motherboard.
O pen the device. (Page
4
7 1). This is not necessary
2
Operating Instructions, 12/2010, A5E02669337-02
6 5).
2
SIMATIC IPC647C