Preventive Maintenance; Replacing Filters - Siemens Simatic IPC647C Operating Instructions Manual

Service and maintenance
11.1 Removing and installing hardware components
Tools
You can perform all installation tasks on the device using Torx T6, T10, T20, crosshead PH
no. 1 screwdrivers, a 4.5-mm hexagonal wrench (for the interface locking mechanism on the
rear panel) and a side cutter.
11.1.2

Preventive maintenance

To maintain high system availability, we recommend the preventative exchange of those PC
components that are subject to wear. The table below indicates the intervals for this
exchange.
HDD
3 years
11.1.3

Replacing filters

Preparing for filter replacement
Note
You may only use filters of the same type. Information about original spare parts for
SIMATIC PCs is available on the Internet at: After-sales information system for SIMATIC
PC/PG (
Filter meshes are available under the following order number: A5E02318854.
92
Fan
3 years
h ttp://www.siemens.com/asis)
5
CMOS backup battery
5 years
Operating Instructions, 12/2010, A5E02669337-02
Air filter mat
Depending on the degree of
soiling
SIMATIC IPC647C