Resetting With Unconfigure; Obtaining The Network Address - Siemens Simatic IPC647C Operating Instructions Manual

16.6.4

Resetting with Unconfigure

Note
If the AMT PC still has its factory settings, for example has just been purchased, you can
skip this section.
If you have already configured AMT previously, it is best to discard all the previous AMT
settings made in the MEBx.
NOTICE
All previous settings in the management engine are deleted.
Correct operation in the plant may be at risk.
Note down all the settings in the MEBx. Make the settings again as necessary following
Unconfigure.
To reset the AMT settings, follow these steps:
62. Enable the "Unconfigure ME" entry in "Advanced > Active Management Technology
63. Exit the BIOS with the <F10> key "Save and Exit". The AMT PC restarts.
64. After the restart, a user prompt appears asking whether you really want to discard all the
65. Confirm with "Y". On a German keyboard, this means pressing the <Z> key.
The device continues to boot with the factory settings of the management engine.
16.6.5

Obtaining the network address

Introduction
To connect the AMT PC with the AMT server, the network address that uniquely localizes
the AMT server on the AMT PC must be entered.
If DHCP is set for the automatic assignment of the network address in "Network Setup" in
the MEBx of the AMT PC, the network address is not fixed.
SIMATIC IPC647C
Operating Instructions, 12/2010, A5E02669337-02
Support" in the BIOS.
settings in the management engine:
16.6 AMT (Active Management Technology)
Detailed descriptions
207