Installation And Removal Of Expansion Modules; Overview Of The Expansion Modules; Installation And Removal Of The Bus Frame - Siemens Simatic IPC647C Operating Instructions Manual

10.3

Installation and removal of expansion modules

10.3.1

Overview of the expansion modules

Notes on module specifications
The device is designed for use with modules to PCI specifications 2.3 or 1.0a. The module
supports operation of 5 V and 3.3 V PCI modules. Compliance with the defined mechanical
defaults is imperative. Failure to comply with these defaults can result in contact problems,
malfunctions and assembly difficulties. The permitted module contour dimensions are
specified in the
section.
Note about long PCI, PCIe modules
Long PCI / PCIe modules must be fitted with an extender for insertion into the guide rails
(should be supplied with the long PCI PCIe board.)
Note on PCI-Express x16 modules
The modules in the PCIe x16 slot can take up two slots.
Note on PROFINET expansion modules
The "CP 1616 onboard" option must be disabled in the BIOS for devices with CP 1616
onboard, before a PROFINET module (such as a CP 1616) can be installed in the system.
10.3.2

Installation and removal of the bus frame

Preparation
Disconnect the device from the mains and unplug all cables.
Open the device as described in section
SIMATIC IPC647C
Operating Instructions, 12/2010, A5E02669337-02
D imensional drawings for installation of expansion modules (Page
3
Expansions and parameter assignment
10.3 Installation and removal of expansion modules
O pen the device. (Page
4
1 45)
2
6 5).
2
71