Processor Replacement; Reinstalling The Software; General Installation Procedure - Siemens Simatic IPC647C Operating Instructions Manual

Installing a CPU cooler
How to install the CPU cooler
1. Make sure that the heat sink pad
2. Perform the tasks describe above
11.1.11

Processor replacement

Removing the processor
Since the processor is soldered to the motherboard, it has to be replaced completely.
Observe the information in the Chapter
11.2

Reinstalling the software

11.2.1

General installation procedure

If your software is corrupt, you can reinstall it using the recovery CD or DVD, the
Documentation and Drivers CD and the Restore DVD.
SIMATIC IPC647C
Operating Instructions, 12/2010, A5E02669337-02
on the CPU cooler is intact.
in reverse order. Turn all the
screws diagonally and tighten them
uniformly, alternating to prevent
skewing.
R emoving the motherboard (Page
7
Service and maintenance
11.2 Reinstalling the software
1 05).
3
109