Bios Recovery - Siemens Simatic IPC647C Operating Instructions Manual

11.4

BIOS Recovery

The "BIOS-Recovery" function is used to reinstall the device when a BIOS is unusable.
All BIOS Setup settings will be lost in the recovery. You have to set these values again after
a successful recovery.
Procedure
37. Switch off the device.
38. Remove the device cover and install the jumper on the main board as described in
39. Close the housing cover.
40. Place the Siemens BIOS Update USB stick into an USB slot of the device front.
41. Connect the device to the power supply.
42. Turn off the device after recovery.
43. Install the jumper
44. Remove the BIOS Update USB stick.
45. Switch the device on.
46. Press <F2> to open the BIOS Setup.
47. Adjust the BIOS setup values once again, if necessary.
SIMATIC IPC647C
Operating Instructions, 12/2010, A5E02669337-02
"Recovery". The jumper is located at the edge of the main board between the slots for
①
memory modules and the fan connector
Recovery is executed automatically and cannot be interrupted or operated. The recovery
progress will be displayed on the screen.
①
on "park position" and close the device.
②
.
1 2
Service and maintenance
11.4 BIOS Recovery
121