Siemens Simatic IPC647C Operating Instructions Manual page 139

General specifications
Ethernet
Audio
- Microphone
- Line out / Headset
Status displays (LEDs)
Approvals / manufacturer's declarations
cULus
CE
*
1
2
3
4
5
6
SIMATIC IPC647C
Operating Instructions, 12/2010, A5E02669337-02
4
Electrical isolation within the safety extra-low voltage circuit (SELV)
Mechanical interference must be safely excluded within the burning operation.
Restrictions when HDDs are mounted in removable racks:
Shock to 5G permissible. Otherwise, mechanical stress must be safely excluded.
The two flashing red LEDs indicate that the RAID system is being synchronized.
Both red LEDs are lit if the monitoring software was unable to locate the faulty HDD. It may be
possible to locate this HDD using the RAID software. See section
LAN interfaces are numbered on the enclosure to provide unique identification. The numbering
by the operating system may deviate from this.
AMT and teaming cannot be used simultaneously on the Ethernet interface.
Interfaces supplied as optional.
2 x Ethernet interface (RJ-45), wake on LAN, remote boot and
teaming are supported.
10/100/1000 Mbps, electrically isolated *
Ethernet 1: 82577 L, IAMT-capable
up to 4088 bytes
Ethernet 2: Intel 82574 L, supports jumbo frames up to 9014
bytes
IDT 92HD81HD
2x 0.5 W / 8 Ohm
Labeling on the LED color
front panel
POWER Green
Yellow
HDD Green
ETHERNET 1 Green
4
ETHERNET 2 Green
4
PROFIBUS/MPI Green
SF PROFINET Red
5
Flashing red
WATCHDOG Green
Red
TEMP Red
FAN Red
HDD 1 Red or both
HDD 2 red, or
red flashing
60950-1
For details refer to Appendix A1 and manufacturer's
declaration
Technical specifications
14.1 General specifications
, supports jumbo frames
5
Meaning
Device active
standby
HDD active
Active
Active
Active
No cable connected or
fault
Fault or node flash test
function
Active
Alarm
Temperature alarm
Fan alarm
Hard disk alarm in
conjunction with
SIMATIC monitoring
3
software
R AID monitoring (Page 6 2).
8 3
139