Bios Setup Default Settings - Siemens Simatic IPC647C Operating Instructions Manual

16.5.12

BIOS Setup default settings

Documenting your device configuration
If you have changed any default settings in Setup, you can enter them in the following table.
You can then refer to these entries for any future hardware modifications.
Note
Print out the table below and keep the pages in a safe place once you made your entries.
Note
The default setup settings vary depending on the ordered device configuration.
If you have changed any default settings in Setup, you can enter them in the following table.
You can then refer to these entries for any future hardware modifications.
BIOS Setup default settings
System parameters
Main
System Time
System Date
System parameters
Advanced>Peripheral
Configuration
Internal COM 1
Internal COM 2
Internal LPT
Audio
Onboard Ethernet 1
Onboard Ethernet 2
PCI – MPI / DP
Profinet
System parameters
Advanced>SATA Configuration
SATA Controller
SATA Controller mode
SIMATIC IPC647C
Operating Instructions, 12/2010, A5E02669337-02
Default settings
hh:mm:ss
MM/DD/YYYY
Default settings
Auto
Auto
Auto
Enabled
Enabled
Enabled
Enabled
Default settings
Enabled
AHCI
Detailed descriptions
16.5 BIOS Setup
Local settings
Local settings
Local settings
201