Removal And Installation Of Drives; Removal And Installation Of The Hard Disk Drive - Siemens SIMATIC Box PC 840 Manual

4.5

Removal and Installation of Drives

4.5.1

Removal and Installation of the Hard Disk Drive

1. Undo the 4 screws of the drive holder.
2. Open the drive holder.
3. Detach the drive holder from the mounting and lay the drive holder with its top
on the housing.
4. Note the cable assignment and pull off the cables.
5. Undo the four screws which secure the hard disk drive to the vibration-damped
part of the mounting. Remove the hard disk drive from the mounting.
6. Proceed in the reverse order to fit the new drive. The new drive must be of the
same type as the one removed.
Figure 4-10 Installation and Removal of the Drive Holder
SIMATIC Box PC 840 Manual
A5E00085984-04
SIMATIC Box PC 840 Expansions
Fixing screws
4-15