Installation Instructions - Taylor C832 Service Manual

Installation Instructions

The following are general installation instructions.
For complete installation details, please see the
checkout card.
Site Preparation
Review the area where the unit is to be installed
before uncrating the unit. Make sure all possible
hazards to the user and the equipment have been
addressed.
For Indoor Use Only: This unit is designed to
operate indoors, under normal ambient
temperatures of 70° ­ 75°F (21° ­ 24°C). The unit
has successfully performed in high ambient
temperatures of 104°(40°C) at reduced capacities.
This unit must be installed on a level surface
to avoid the hazard of tipping. Extreme care should
be taken in moving this equipment for any reason.
Two or more people are required to safely move this
unit. Failure to comply may result in personal injury
or equipment damage.
When uncrating the unit, inspect the unit for
damage. Report any damage to your Taylor
Distributor.
This piece of equipment is made in the USA and has
USA sizes of hardware. All metric conversions are
approximate and vary in size.
Introduction
Electrical Connections
Three dedicated electrical connections are required
for the models C832, C834, C842, and C844 (two 3
phase and one interlock/control single phase). Two
dedicated electrical connections are required for the
models C835, C836, C838, and C845 (one 3 phase
and one interlock/control single phase). Check the
data plate on the grill for voltage, cycle, phase and
electrical specifications. The power connections are
located behind the access line cover on the rear of
the control box under the front staging side of the
grill.
In the United States, this equipment is intended to
be installed in accordance with the National
Electrical Code (NEC), ANSI/NFPA 70-1987. The
purpose of the NEC code is the practical
safeguarding of persons and property from hazards
arising from the use of electricity. This code contains
provisions considered necessary for safety.
Compliance therewith and proper maintenance will
result in an installation essentially free from hazard!
In all other areas of the world, equipment should be
installed in accordance with the existing local codes.
Please contact your local authorities.
The proper wire size and fused circuit should be
selected according to grill data label information.
Incoming power must be connected to the terminals
with black characters on a white background.
This equipment must be properly
grounded!
Do not operate this unit unless it is properly
grounded and all service panels and access doors
are restrained with screws. Failure to do so can
result in severe personal injury from electrical shock!
This equipment is provided with a grounding lug
that is to be properly attached to the rear of the frame
by the authorized installer. The installation location is
marked by the equipotential bonding symbol (5021 of
IEC 60417-1) on the removable panel and the frame.
4
McDonald's Intelligap Grills