Taylor C832 Service Manual page 36

n. The AUTO GAP screen will display. This screen
shows two sets of numbers. The first set of
numbers is the minimum gap and second set of
numbers is the maximum gap of the item.
10:1 - CLAM
AUTO GAP:
o. Adjust the setting of the 1
performing Steps 2 - 4 from the Remove Gap
section on page 25. After pressing the OK key,
the cursor moves to the 2
Repeat the procedure to adjust the 2
p. The screen will display "AM __ PM __". Use the
keys to scroll to the appropriate
selection and press the
Removing Optional Menu Items
Core menu items cannot be removed. However,
menu items programmed using the "ADD ITEM"
menu option can be removed .
Step 1
Press the key for "MENU ITEMS".
Step 2
Use the keys to scroll to menu item to
be removed.
Step 3
Press the key until "REMOVE IN" displays.
Step 4
Press and hold the
menu item is removed.
130731
Controls and Systems
230 TO 330
st
set of numbers by
nd
set of numbers.
nd
setting.
key.
key for 5 seconds, until the
Factory Default Settings Reset
Procedures
Perform the following steps to reset the control to
the factory default settings. This feature is available
on software version 2.78 and higher.
Note: Resetting to defaults will default the control to
the 3 platen electric configuration. To reset to a
different configuration (example: 2 platen control),
the setting must be changed in System Set Up.
Step 1
Place the power switch in the ON position and wait
for the control to display "OFF."
Step 2
Press the key once. Then press the following
keys in succession:
The following screen will display.
PRESS ENTER FOR
Step 3
Press and hold the
following screen displays.
RESET CORE MENU?
30
MENU ITEMS
key for 5 seconds until the
NO
McDonald's Intelligap Grills
.