Environmental Notices - Taylor C832 Service Manual

Appliances that are permanently connected
to fixed wiring and for which leakage currents may
exceed 10 mA, particularly when disconnected, not
used for long periods, or during initial installation,
shall have protective devices such as a GFI, to
protect against the leakage of current, installed by
the authorized personnel to the local codes.
Stationary appliances which are not
equipped with a power cord and a plug or another
device to disconnect the appliance from the power
source must have an all­pole disconnecting device
with a contact gap of at least 3 mm installed in the
external installation.
Supply cords used with this unit shall be
oil­resistant, sheathed flexible cable, not lighter than
ordinary polychloroprene or other equivalent
synthetic elastomer­sheathed cord (Code
designation 60245 IEC 57). They must be installed
with the proper cord anchorage to relieve conductors
from strain, including twisting, at the terminals and
protect the insulation of the conductors from
abrasion.
The main power supply(s) to the grill must
be disconnected prior to performing any repairs.
Failure to follow this instruction may result in
personal injury or death from electrical shock or
hazardous moving parts, as well as poor
performance or damage to the equipment.
Note: Grills require electrical power for operation. In
the event of a power outage, place the unit in the
OFF position.
DO NOT install the grill in an area where a
water jet could be used to clean or rinse the grill.
Failure to follow this instruction may result in serious
electrical shock.
McDonald's Intelligap Grills
Ventilation and Clearance
To ensure proper operation of this appliance, it must
be installed away from all combustible products.
Failure to allow proper clearance and airflow
may cause poor performance, damage to the
machine, or unsafe operating conditions.
After set up, DO NOT store anything on top
of this appliance. Failure to follow this instruction
may result in a fire.
DO NOT store flammable vaporous, liquids,
or combustible material in the vicinity of the grill.
This includes, but is not limited to walls, floors,
partitions, furniture, curtains, and decorations.
Grease Disposal Container
In order to comply with NSF Standard 4
requirements, an appropriate grease disposal
container must be provided. This container is
supplied by the KES, not the Taylor Company.

Environmental Notices

______________________________
If the crossed-out wheeled bin symbol is
affixed to this product, it signifies that this product is
compliant with the EU Directive for Waste Electric/
Electronic Goods (WEEE) as well as other similar
legislation in effect after August 13, 2005. Therefore,
it must be collected separately after its use is
completed and cannot be disposed of as unsorted
municipal waste.
The user is responsible for returning the product to
the appropriate collection facility, as specified by
your local codes.
For additional information regarding applicable local
laws, please contact the municipal facility and/or
local distributor.
5
Introduction