Taylor C832 Service Manual page 33

Step 3
The screen will display "BOTTOM TEMP ___".
10:1 - CLAM
BOTTOM TEMP: 375F
Step 4
To adjust the setting, repeat Steps 2 - 4 from the
Remove Gap section on page 25.
Auto Selection
This feature is used to determine if the cooking
functions of a product will be automatically selected
or not.
Step 1
After selecting the item, press the
screen displays "AUTO SELECTION".
Example of a screen:
10:1 - CLAM
AUTO SELECTION: YES
Step 2
To change the selection, press the
until the desired selection (YES or NO) is displayed.
Press the key to save the changes.
McDonald's Intelligap Grills
Auto Gap
IMPORTANT! These settings should not be
changed unless authorized by a Taylor Service
Representative. This change should only be
performed to adjust deformed product. Before
attempting to change the product thickness settings,
cook the deformed product in the MANUAL mode.
Step 1
Press the
GAP". The screen will show two sets of numbers.
The first set of numbers is the minimum gap of the
item. The second set of numbers is the maximum
gap of the item.
Step 2
To adjust the setting for the 1
repeat Steps 2 - 4 from the Remove Gap section on
page 25.
After the OK key was pressed, the cursor moved to
nd
the 2
numbers and press the OK key.
Programming Optional Menu Items
key until the
This feature is used to add optional menu items.
Step 1
Access the Control Menu by entering the Service
Menu passcode, per instructions on page 23.
Step 2
Press the
"MENU ITEMS".
Step 3
Press the
keys
27
key until the screen displays "AUTO
10:1 - CLAM
AUTO GAP: 230 TO 330
st
set of numbers,
set of numbers. Adjust the second set of
key until the screen displays
key to scroll to "ADD ITEM".
ADD ITEM
Controls and Systems
141020