Table of Contents
Advertisement
Recalling Data by Specifying the Corresponding Memory Number
Deleting Data
Displaying the Number of Data Items Which Can Be Stored
IM 767361-01E
2.
Press No. while recall mode is active.
3.
Use
,
, or
to select the desired memory number.
4.
Press ENTER/LOCAL to recall the data.
5.
To cancel recall mode, press RECALL again. RECALL disappears from the
screen.
Note
•
If recall is performed from a memory number in which no data has been stored, error code
will be displayed, and the
• If the desired data is relative display data, it cannot be recalled if % display or %ERROR
display is active. In this case, display is switched automatically to the normal display screen.
Data stored in the internal memory can be deleted. Two methods are available;
one is used to delete the desired data by specifying the corresponding memory
number and the other is used to delete all data at once.
1.
Press the DELETE.
2.
Press
or
to select
press ENTER/LOCAL.
3.
If
is selected, specify the delete start and stop memory numbers.
If
is selected, skip to step 4.
Delete start memory Number setting screen:
Delete stop memory Number setting screen:
Use
,
, and
to set both the start and stop memory numbers, then press
ENTER/LOCAL.
4.
In the delete execution setting screen, select
or
if you do not, then press ENTER/LOCAL. Press DELETE to return to the
normal measurement screen.
The possible number of data to be stored can be displayed.
1.
Press MENU.
2.
Keep pressing
or
3.
The number of data items which can be stored is displayed for approximately one
second.
4.
To return to the normal measurement screen, press MENU.
Storing and Recalling Data (MT220 Only)
screen will appear.
(partial delete) or (delete all data),
if you want to delete the data
until
is displayed, then press ENTER/LOCAL.
then
45
Advertisement
Table of Contents
