Table of Contents
Advertisement
Storing and Recalling Data (MT220 Only)
Manual Store
Data Recall
Recall Mode
Recalling Data Sequentially
44
Pressing the STORE key stores data. If no destination memory number is
specified, the data is stored under the memory number immediately following
the one in which the last data item was stored.
Making Manual Store Settings
1.
Press MENU.
2.
Keep pressing
ENTER/LOCAL to proceed to the store mode setting screen.
3.
Press
or
to display
4.
To return to the normal measurement screen, press MENU.
5.
Press No. to display the memory number setting screen (
6.
Use
,
and
Storing Data
7.
Pressing STORE stores data and displays
screen, while the memory number to which the data is being stored is displayed in
the lower part of the screen for approximately 0.5 seconds.
Note
•
It is not possible to overwrite data. If a destination memory in which data already exists is
selected, error code
store, error code
in which data already exists is reached. If you want to store data in a memory in which data
already exists, delete the existing data first, then store the new data.
•
All data stored in the internal memory will be backed up even if the power is turned OFF.
Data stored in the internal memory can be recalled. Specify the number of the
data items you want to recall.
The set-up information which was in effect when the last store was performed
will be restored when a recall is performed.
• Relative value display ON/OFF
• DMM function ON/OFF, selected measurement item (current or voltage)
• Pressure values specified as 0% and 100% in the case of % display
When recall mode is cleared, the settings which were effective before the recall
will be restored.
RECALL is displayed during recall mode.
1.
Press RECALL.
RECALL lights up on the screen, indicating that recall mode is now active and the
latest stored data is recalled.
2.
When you press
recalled is incremented or decremented, and the corresponding data will be
recalled.
3.
To cancel recall mode, press RECALL again. RECALL disappears from the
screen.
or
until
is displayed in the screen, then press
, then press ENTER/LOCAL to select the mode.
to set the desired memory number, then press ENTER/LOCAL.
will be displayed, indicating that overwriting is not possible. In auto
is displayed and auto store stops automatically when a memory number
or
while in recall mode, the number of the data to be
).
in the upper part of the
IM 767361-01E
Advertisement
Table of Contents
