Table of Contents
Advertisement
Getting started
First time operation
When operating your new fi replace for the fi rst time,
some vapors may be released due to the burning of
curing compounds used during manufacturing. They
may cause a slight odor and could cause the fl ames
to be the full height of the fi rebox, or even slightly
higher, for the fi rst few hours of operation.
It is also possible that these vapors could set off any
smoke detection alarms in the immediate vicinity.
These vapors are quite normal on new fi replaces.
We recommend opening a window to vent the
room. After a few hours of use, the vapors will have
disappeared and the fl ames will be at their normal
height.
Valor safety gas shut-off
For your safety, Valor fi replaces are fi tted with a
fl ame supervision device which will shut-off the gas
supply if, for any reason, the pilot fl ame goes out.
This device incorporates a fi xed probe, which senses
the heat from the pilot fl ame. If the probe is cool,
the device will prevent any gas fl ow unless manually
lighting the pilot. See the full Fireplace and Lighting
Information card attached to the fi replace or as
reproduced in Appendix A of the Installation Manual.
WARNING
Do not attempt to access the card while
the fi replace is hot! Let the fi replace cool
fi rst before touching it!
Locating fi replace and lighting information
The Fireplace and Lighting Information card is located
under the fi rebox.
To access the card, remove the barrier screen, the
fret or bottom panel., and pull the card out.
There is important information on both sides of the
card. It must be left with the fi replace when you are
done.
Fireplace model
Warranty
QR code
Serial number
7
Advertisement
Table of Contents
