Getting Started; First Time Operation; Locating Fi Replace And Lighting Information - Valor RetroFire RF24DJN Homeowner's Manual

Getting started

First time operation

When operating your new fi replace for the fi rst time,
some vapors may be released due to the burning of
curing compounds used during manufacturing. They
may cause a slight odor and could cause the fl ames to
be the full height of the fi rebox, or even slightly higher,
for the fi rst few hours of operation.
It is also possible that these vapors could set off any
smoke detection alarms in the immediate vicinity.
These vapors are quite normal on new fi replaces. We
recommend opening a window to vent the room. After
a few hours of use, the vapors will have disappeared
and the fl ames will be at their normal height.
Valor safety gas shut-off
For your safety, Valor fi replaces are fi tted with a fl ame
supervision device which will shut-off the gas supply
if, for any reason, the pilot fl ame goes out. This device
incorporates a fi xed probe, which senses the heat
from the pilot fl ame. If the probe is cool, the device
will prevent any gas fl ow unless manually lighting the
pilot. See the full Fireplace and Lighting Information
card attached to the fi replace or as reproduced in
Appendix A of the Installation Manual.
Locating fi replace and lighting information
WARNING
Do not attempt to access the card while
the fi replace is hot! Let the fi replace cool
fi rst before touching it!
The Fireplace and Lighting Information card is located
under the fi rebox.
To access the card, unhook the bottom cover or fret,
and pull the card out.
There is important information on both sides of the
card. It must be left with the fi replace when you are
done.
Fireplace
model
739MN
FOR NATURAL GAS POUR LE GAZ NATUREL
Serial
number
CIRCULATING FAN KIT 755CFK VENTILATEUR POUR CIRCULATION D'AIR 755CFK
120V, 60Hz, LESS THAN 1A
#4003360-741, #4003293-742, #4003313-745, #4003426-765, #4004666 772
24,000
6,500
3.2"
5.0"
739N 10000
750
120V, 60Hz, MOINS DE 1A
4006176N/01
7