Configuring The Lan Properties - GE PACSystems RX3i User Manual

Chapter 3. Configuration
3.6.1

Configuring the LAN Properties

Machine Edition automatically assigns a set of default properties to the LAN. Select the LAN icon in the LAN
viewer to display or edit its communications properties in the Inspector pane:
Figure 50: Setting the Communication Properties of a LAN
LAN Name: this can be edited or the default name can be used. Space characters are not permitted.
Description: an optional description of up to 255 characters can be entered for the LAN.
LAN ID: (read-only) this number identifies the LAN in the Machine Edition project.
Network Speed: the bandwidth available on the network. The default of 1Gbps can be changed to 100Mbps.
Maximum Utilization (%): the maximum percentage of total network bandwidth that can be used for
PROFINET I/O traffic. It can be edited to any value between 10 and 80 (do not enter the % character). Consider
other network traffic when changing this parameter.
IP Range Lower Limit: the lowest IP Address for automatically assigning IP Addresses to PROFINET
Controllers and LAN devices. Default is 192.168.x.1, where x is the lowest number not used by another LAN in
the project.
IP Range Upper Limit: the highest IP Address for automatically assigning IP Addresses to PROFINET
Controllers and LAN devices. Default is 192.168.x.254, where x is the lowest number not used by another LAN
in the project.
GFK-2571N May 2018 63