Pnc001 Hardware Implementions (-Ax & -Bxxx) - GE PACSystems RX3i User Manual

1.5.1 PNC001 Hardware Implementions (-Ax & -Bxxx)
In January 2018, an updated hardware implementation(-Bxxx) replaced the earlier version (-Ax) of the rack-
mounted PNC001. The following are the differences between these two hardware implementations.
Topic
Appearance
Case
Attachment to Rack
Heatsink
Status LEDs
LED Behavior
Ethernet Port LEDs
µUSB Port
Command Line
Interface
RJ45 Connector on
Faceplate
Power Requirements
Operating
Temperature Range
Module Reset
With the exception of the Command Line Interface, the -Bxxx version is functionally compatible with the -Ax
version.
GFK-2571N
-Ax
Figure 2
Plastic
Via plastic case latch and heatsink screw
Remove plastic knockout from rack
6 LEDs
See Section 2.8
4 singleton LEDs (top of faceplate)
Present
Uses µUSB Port
Absent
Higher (see Section 1.3)
0 to 60°C
Pushbutton "Restart"
May 2018
Chapter 1. Introduction
-Bxxx
Figure 3
Metal
Via two Phillip's head machine screws
No knockout removal required
5 LEDs (no USB LED)
See Section 2.8
4 banks of LEDs (bottom of faceplate)
The digits representing the port
numbers are backlit by LEDs.
Absent
Not available
Present (Disabled)
Lower (see Section 1.3)
-25 to 60°C
Membrane "Reset"
11