Danfoss VLT Instruction Manual page 57

VLT ® HVAC Drive Instruction Manual
NOTE!
When carrying out manual initialization, serial communication, RFI filter settings and fault log settings are reset.
Removes parameters selected in par. 0-25
1. Disconnect from the line power and wait until the display
turns off.
2a. Press [Status] - [Main Menu] - [OK] at the same time as
powering up the Graphical LCP (GLCP).
2b. Press [Menu] while the LCP 101, Numerical Display is pow-
ering up.
3. Release the keys after 5 s.
4. The adjustable frequency drive is now programmed according
to default settings.
My Personal Menu
This parameter initializes all except:
par. 15-00
par. 15-03
par. 15-04
par. 15-05
MG.11.A9.22 - VLT ® is a registered Danfoss trademark
5 How to operate the adjustable frequency
Operating Hours
Power-ups
Over Temps
Over Volts
drive
5
5-7