Danfoss VLT Instruction Manual page 25

VLT ® HVAC Drive Instruction Manual
4.1.5 AC line input connections for A2 and A3
Figure 4.2: First, mount the two screws on the mounting plate, slide it into place and tighten fully.
Figure 4.3: When mounting cables, first mount and tighten ground cable.
The ground connection cable cross-section must be at least 0.016 in
according to EN 50178/IEC 61800-5-1 .
MG.11.A9.22 - VLT ® is a registered Danfoss trademark
2 [10 mm 2 ] or 2 rated line power wires terminated separately
4 Electrical installation
4
4-7