Completion - 2N Helios IP Verso Installation Manual

2.5 Completion

Installation Completion
Check the connection of all wires and the RJ-45 plug to the board connector.
Caution
Nametag Placing
Every intercom package includes a piece of transparent foil, which can be laser printed.
Cut the printed foil and insert the nametags in the buttons.
We recommend you to use separate foil for every button in the 5-button module. Refer
to section download for the nametag printing template.
Nametag dimensions for 5-button module:
1 button: 52.0 (W) x 15.2 (H) mm (dimensional tolerance: +0; - 0.5 mm)
5 buttons: 57.5 (W) x 89.0 (H) mm (dimensional tolerance: +0; - 0.5 mm)
Infopanel nametag dimensions: 69.2 (W) x 86.7 (H) mm (dimensional tolerance: +0; -
0.5 mm).
Caution
Nametag inserting/replacing:
1. Remove the frame.
2. Lift up the button door. The 5-button module buttons have just one door.
3. Remove the used nametag and insert a new one.
4. Close the button door.
5. Replace the frame.
Frame Replacement
Check the frame sealing before replacing the frame.
®
2N TELEKOMUNIKACE a.s., www.2n.cz
All unused connectors have to have tightened screws in order to avoid
vibration caused by sound.
The area where nametags are placed is called a wet zone. After heavy
rain, water can penetrate to the nametag. Water in this area does not
affect the intercom functionality in any way and evaporates soon.
Always use waterproof foil (enclosed or other) for the nametags. Never
use paper or ink jet printing to avoid damage due to water leakage!
115