Mounting Completion - 2N Lift8 Brief Manual

Mounting Completion

1. Having connected all the wires, check the bushings if used for proper tightening.
2. Replace the front cover carefully. Make sure that the wire arrangement inside the device
provides enough space for front panel insertion. Tighten the 4 screws thoroughly to push the
panel by 1 mm further to the metal chassis. Use the Torx 20 spanner for tightening, for
example.
Caution
An improper mounting may result in the audio unit not being waterproof. Water leakage
may damage the electronics.
2N® Lift8 Shaft Antivandal
them, never use other screws to avoid corrosion and screw appearance deterioration!
is assembled with stainless steel screws. If you lose
7