2N Helios IP Verso Installation Manual page 113

To the active 12 V / 700 mA DC output, or
To the relay output with a serial external power supply.
The device also supports a Departure button connected between the 'PB' and '-
HeliosIP' terminals. Press the Departure button to activate the output for 5 seconds.
Status signalling:
Green LED
blinking
on
blinking
on
Configuration:
Connect the
output; refer to the
LED at least on the
Press and hold the
put the device in the programming mode (both the red and green LEDs are
blinking).
Activate the intercom switch using the keypad, telephone, etc. The first code sent
from the intercom will be stored in the memory and considered valid. After code
initialisation, the
mode (the green LED is blinking).
Tip
Tip
®
2N TELEKOMUNIKACE a.s., www.2n.cz
Red LED
off Operational mode
off Activated output
blinking Programming mode – waiting for initialisation
blinking Error – wrong code received
®
2N Helios IP Security Relay
2N Helios IP Configuration Manual
®
2N Helios IP Security Relay
®
2N Helios IP Security Relay
®
2N Helios IP Security Relay
®
FAQ: 2N Helios IP Security Relay – what it is and how to use it with 2N
Helios IP intercom?
Video Tutorial: Door intercoms 2N
Status
to the properly set intercom switch
. Make sure that one
is on or blinking.
Reset button for 5 seconds to
will pass into the operational
®
Helios IP - Security Relay
113