Electric Installation - 2N Helios IP Verso Installation Manual

2.3 Electric Installation

This subsection describes how to install the modules, how to connect the 2N
IP Verso
Mounting Preparation
1. Unscrew the second module cover on the main unit base.
2. Use a flat screwdriver to take out the module cover.
Version A – 2-Module Base
1. Place the base on the flush mounting box / predrilled holes with dowels and pull
the cables through the bottom holes. Pull the Ethernet cable including the
connector through the bottom hole to the left if necessary.
2. Insert the metal fitting elements up and down and screw the base plate tight.
You can level the base slightly if you are mounting just one base.
Version B – 3-Module Base
1. Unscrew the cover of the additional base.
2. Use a flat screwdriver to take out the cover.
3. Slide the additional base to the main unit base and secure its position with the
small side wedges and screws.
4. Remove the microphone from the hlavní unit base and loosen the microphone
cable.
5. Lead the microphone to the third module base as shown in the figure.
6. Place the joined bases on the flush mounting box / predrilled holes with
dowels and pull the cables through the bottom holes. Feed the Ethernet cable
without the connector from the additional base to the main unit base if
necessary.
Version C – Additional Columns
1. Unscrew the cover of the additional bases and take it out with a flat screwdriver.
2. Insert the bases into each other as projected and secure their position with the
small side wedges and screws.
3. Place the cover on the flush mounting box / predrilled holes with dowels and pull
the cables if any through the bottom holes.
4. Pull the bus using the cable bushing available in the flush mounting box.
Main Unit
Power Supply Connection
®
2N Helios IP Verso can be powered either from an external 12 V / 2 A DC source or
directly from the LAN equipped with PoE 802.3af supporting network elements. Owing
to different power outputs, the power supply selection affects the maximum count and
applicability of the modules connected of the main unit.
®
2N TELEKOMUNIKACE a.s., www.2n.cz
main unit to the power supply and LAN and how to connect other elements.
®
Helios
98