2N Helios IP Verso Installation Manual page 120

Note
Dynamic/Static IP Address Switching
Take the following steps to switch the dynamic and static IP address mode in 2N
Helios IP Verso
Connect (or, if connected, disconnect and reconnect)
the power supply.
Wait for the first sound signal
Press the quick dial button on the main unit 15 times.
Switching is signalled with the sound signal
Wait until the device is restarted automatically.
Upon restart, the static IP address mode will be switched to the dynamic IP
address mode and vice versa.
The following network parameters will be set after the static IP address mode is
switched on and the device is restarted:
IP address: 192.168.1.100
Network mask: 255.255.255.0
Default gateway: 192.168.1.1
Note
®
2N TELEKOMUNIKACE a.s., www.2n.cz
Be sure to press the button sequence within thirty seconds after the
sound signal for security reasons. Up to 2 s intervals are allowed between
the presses.
:
Be sure to press the button sequence within thirty seconds after the
sound signal for security reasons. Up to 2 s intervals are allowed between
the presses.
.
.
®
2N Helios IP Verso
120
®
to