Comtech EF Data PCB-4000A Installation And Operation Manual page 64

Command
Command
Parameter
(Instruction Valid for
Type Code and PCB or
SSPA
qualifier)
SNMP STV= PCB
Trap Version
Time Protocol TPE= PCB
Enable
Time Protocol TPS= PCB
Server
Restore RFD= PCB
Factory
Defaults
Serial Remote Control
Arguments for
Description of Arguments
Command or
(Note that all arguments are ASCII numeric codes – i.e.,
Response to
ASCII codes between 48 and 57)
Query
1 byte Command or Query.
SNMP Trap Version that will be used to send traps.
1 = SNMP Trap Version 1
2 = SNMP Trap Version 2
Example: <1/STV=0
1 byte, Command or Query.
numerical 0 = Time protocol disabled
1 = Time protocol enabled
Example: TPE=1 (Time protocol enabled)
Default Value: 255 or 0
15 bytes, Command or Query.
alpha-numeric Used to set the Time Server IP address for the Unit. Tx
Ethernet management port, in the format:
xxx.xxx.xxx.xxx, where:
xxx.xxx.xxx.xxx is the Time server IP address
Example: TPS=192.168.001.005
Default Value: 255.255.255.255 or 0.0.0.0
None Command only.
Restores factory defaults in the NVRAM
Example: RFD='cr'
Response to
Command
(Target to
Controller)
STV =
STV!
TPE=
TPE?
TPS=
TPS?
RFD=
RFD?
RFD*
5–16
PCB-4000A 1+1 Phase Combiner
Revision 2
Query Response to
Query Valid
Query
(Instruction
for PCB or
Code and (Target to
SSPA
qualifier) Controller)
STV? PCB STV =x
(See
description of
arguments)
TPE? PCB TPE=x
(see
description of
arguments)
TPS? PCB TPS=
xx.xxx.xxx.xxx.
yy (see
description of
arguments)
N/A PCB N/A
MN-PCB-4000A