Figure 4-2. Temporary Folder Setup Using Windows Desktop - Comtech EF Data PCB-4000A Installation And Operation Manual

3. Obtain the firmware number for the PCB-4000A.
•
On the PC: Via serial remote control, obtain the firmware number by using the
<1/FRW? query.
See Chapter 5. SERIAL REMOTE CONTROL for information and
instructions on using remote commands and queries via the PCB-4000A
Serial Interface.
4. Create a temporary folder (subdirectory) on the user PC for the firmware archive download.
•
•
There are several ways you may use create a temporary folder on a Windows-based PC:
a. Use the Windows Desktop to create and rename the temporary folder.
•
Right-click anywhere on the desktop to open the popup submenu, and then select
New > Folder to create the temporary folder. The new folder will be created on the
desktop.
•
Right-click on the new folder and then select "Rename" from the popup submenu.
Rename this folder to "temp" or some other convenient, unused name.
Updating Firmware
Drive letter "c:" is used in these examples. Any valid, writable drive
letter can be used.
Typical for all tasks: Type the command without quotes, and then press
Enter to execute.

Figure 4-2. Temporary Folder Setup using Windows Desktop

PCB-4000A 1+1 Phase Combiner
4–3
Revision 2
MN-PCB-4000A