Table of Contents
Advertisement
Chapter 6. ETHERNET-BASED
6.1
Overview
Ethernet-based Remote Product Management is available using the SYSTEM COM | J1
connector.
PROCEED WITH ETHERNET-BASED REMOTE PRODUCT MANAGEMENT ASSUMING
THAT:
•
The PCB-4000A is operating with the latest version firmware files.
•
The PCB-4000A is connected to a user-supplied, Windows-based PC, and:
o
6.2
Ethernet Management Interface Protocols
The user PC facilitates access to Ethernet-based remote monitor and control (M&C) of the
PCB-4000A through the Simple Network Management Protocol (SNMP). This non-secure
interface requires a user-supplied Network Management System (NMS) and a user-supplied
Management Information Base (MIB) File Browser.
SNMP user interface is only available when the unit's Local/Remote state is set to Ethernet
Remote through LRS serial remote command (LRS=3).
6.3
SNMP Interface
The SNMP is an Internet-standard protocol for managing devices on IP networks. An SNMP
managed network consists of three key components:
•
The managed device. This includes the PCB-4000A.
•
The SNMP Agent. The software that runs on the PCB-4000A. The SNMP Agent
supports both SNMPv1 and SNMPv2c.
•
The user-supplied NMS. The software that runs on the manager.
Ethernet-based Remote Product Management
REMOTE PRODUCT
The PC Ethernet port is connected to the PCB-4000A SYSTEM COM | J1
connector.
PCB-4000A 1+1 Phase Combiner
MANAGEMENT
6–1
Revision 2
MN-PCB-4000A
Advertisement
Table of Contents
