Ikegami HDK-55 Operation Manual page 91

1
Select "1" or "2" from MENU (1/3) "VF DISPLAY" - "DISPLAY MODE."
Characters appear in the viewfinder.
Reference:
Refer to "5.2 Settings from the Menu", "Menu Configuration and content" (page 83) for how to display characters in the
viewfinder.
2
Set the SHUTT/SUP-V switch on the right side of the camera to SET.
One of the following modes is displayed:
- Preset shutter speed
- Variable shutter speed
- SUPER-V
Note:
Each time the SHUTT/SUP-V switch is pressed to the SET position, the mode switches in the order of preset shutter, variable
shutter and SUPER-V.
3
Select "PRESET SHUTTER SPEED" or "VARIABLE SHUTTER SPEED."
4
While the characters are flashing in the viewfinder, turn the rotary pulse switch to the appropriate shutter speed
and press the SET button.
The value will be confirmed.
Note:
- The flashing stops automatically in approximately 3 seconds after the setting operation ends.
- When the characters are not flashing in the viewfinder, press the SET button. The characters will start flashing and the
shutter speed setting will be enabled.
- There are three ways to confirm the shutter speed:
- Press the SET button.
- Wait until the flashing stops.
- Set the SHUTT/SUP-V switch to OFF. The displayed speed is maintained until the switch is set to ON. The shutter speed
is validated when the switch is set to ON.
To cancel the Shutter Speed
■
1
Set the SHUTT/SUP-V switch to OFF.
5.1 Settings Using Switches on the Camera
HDK-55 1206 VER1 (U)
5
75