Monitor Connection; Connecting Camera And Monitor - Ikegami HDK-55 Operation Manual

3.4 Monitor Connection

This section explains how to connect the HDK-55 to the monitor.

Connecting Camera and Monitor

There are three connectors on the rear of the camera to output various video signals. The type of video signal output from each
connector is different. Be sure to connect to a correct connector via a coaxial cable in accordance with the monitor to be used.
- Q-TV/GL, MON OUT connector : Selection between Q-TV/GL and MON OUT is made by the Q-TV/GL, MON OUT SELECT
- SDI OUT connector
- MON SDI connector
Camera rear view
Via 5CFB coaxial cable
with a maximum length of 100m
switch.
If Q-TV/GL is selected, this connector outputs the Q-TV OUT/VBS signal when the camera
is connected to the BS, or it inputs an external synchronization signal (GENLOCK) when the
camera is used stand-alone.
When MON is selected, this becomes the monitor output of the camera images, and the same
image signals are output as the viewfinder.
: Outputs the digital serial video signal. Applicable to the HDTV SDI signal (not applicable to
the SDTV SDI signal).
: Outputs the digital serial video signal. Applicable to the HDTV SDI signal (not applicable to
the SDTV SDI signal).
MON OUT
connector
HD SDI OUT
connector
VIDEO IN
connector
75 Ω termination
Coaxial cable
HDK-55 1206 VER1 (U)
75 termination
Ω
Coaxial cable
VIDEO IN connector
SDI-capable
HD color monitor
VIDEO IN
connector
HD B/W monitor
3.4 Monitor Connection
HD B/W monitor
or
SDI-capable HD
color monitor
51
3