Ikegami HDK-55 Operation Manual page 101

Menu Item
INFORMATION
MPU MODULE SW
WORKING TIME
SUB TIME
VERSION
MPU ROM
D.PROC (PRE)
D.PROC (POST)
OPT-PULSE
DRIVE PULSE
MPU
SDI-TRX
■ MENU (2/3)
Menu Item
VIDEO OUTPUT MODE
SDI OUT
MON SDI OUT
MON ANA OUT
Q-TV ANA OUT
AUX ANA OUT
VBS CONFIG
ASPECT
SET UP
MID/HIGH GAIN MODE
MID GAIN
HIGH GAIN
BATTERY WARNING
BATT WARN VOLT
BARS MODE
BARS MODE
BARS ON
Initial
Setting value
setting
--- MPU substrate DIP SW
****.*H (information
---
display)
****.*H(information
---
display), RESET
STR5656V**.**.**
---
(information display)
--- (information display)
---
---
---
(information display)
---
---
---
Initial
Setting value
setting
ON ON, OFF
VF VF, MAIN, RETURN
MON MON, SYNC
Q-TV1 Q-TV1, Q-TV2, OFF, VBS
VBS Q-TV1, Q-TV2, OFF, VBS Selects the output signal of the AUX output connector.
SQUEEZE, LETTER BOX,
SQUEEZE
SIDE CROP
0% 0%, 7.5%
-3dB -6 to +12dB
+6dB -3 to +18dB
11.0V 10.5 to 13.5V
Destination
FULL, MULTI
setting
OFF ON, OFF
HDK-55 1206 VER1 (U)
5.2 Settings from the Menu
Description, Remarks
Displays the DIP switch settings of the MPU module.
Displays the total accumulated operation time of the camera up
to the present.
Displays the camera's calculated operation time.
Differs from WORKING TIME because it can be reset by the
user.
Number to control the structure of the camera software and
FPGA.
(Regarding the SDI-TRX, because it is on the FA side, it is not
included in this control number).
Displays the camera software version.
Displays the FPGA version.
Description, Remarks
Turns the HD-SD signal (mainline) output ON/OFF.
Switches the signals (HD-SDI) output from the MON SDI
OUT connector.
VF : Outputs same signals as VF images.
MAIN : Outputs main line signals.
RETURN : Outputs RET signals.
MON : Outputs micro-analog HD signals for monitor.
SYNC : Outputs 3-value SYNC signals.
Selects output signals from Q-TV output connector.
VBS is the down convert signal of the main line signal.
Sets the output of the down convert signal of the main line
signal.
Selects whether or not to attach 7.5% setup level to VBS output.
Becomes 0 if scan format is 1080i/50.
Sets the gain values allocated to the M and H positions of the
GAIN SELECT switch on the right side of the camera.
Sets the medium gain value allocated to the M position of the
GAIN SELECT switch.
Sets the high gain value allocated to the H position of the
GAIN SELECT switch.
Sets the battery voltage threshold to display warning.
FULL : Displays the BARS signal conventionally used.
MULTI : Displays the multiformat BARS signal.
Turns the color bar signal ON/OFF.
MENU DATA
ALL VF
- -
- -
- -
- -
- -
- -
MENU DATA
ALL VF
5
-
-
-
-
-
-
-
-
-
-
-
- -
85